Modbus 485 and Modbus IP Protocols - UPS Systems
165 Liebert® IntelliSlot® Modbus/BACnet IP
Inlet Air Temperature The temperature of the inlet air
Input Breaker (CB1/RIB) Input breaker (CB1/RIB)
Input Contact 01 The external input contact 1
Input Contact 02 The external input contact 2
Input Contact 03 The external input contact 3
Input Contact 04 The external input contact 4
Input Contact 05 The external input contact 5
Input Contact 06 The external input contact 6
Input Contact 07 The external input contact 7
Input Contact 08 The external input contact 8
Input Contact 09 The external input contact 9
Input Contact 10 The external input contact 10
Input Contact 11 The external input contact 11
Input Contact 12 The external input contact 12
Input Contact 13 The external input contact 13
Input Contact 14 The external input contact 14
Input Contact 15 The external input contact 15
Input Contact 16 The external input contact 16
Input Filter Cycle Lock The input filter disconnect is ope n due to exceeding the maximum number
of cycles.
Input Isolation Transformer Input isolation transformer
Input Qualification Status input qualification status
Internal Bypass Breaker (CB3) Internal bypass breaker (CB3)
Internal Communications Failure The control has detected a communication failure of a component on the
internal communication bus
Inverter Failure Inverter failure - inverter output is off
Inverter Inhibit - External Restart of the inverter is inhibited by an external signal
Inverter Off - External Inverter is off (operation is inhibited) due to external signal state
Inverter On/Off State inverter on/off state
Inverter Output Qualification Status inverter output qualification status
Inverter Overload Phase A Inverter is operating with an overload on phase A
Inverter Overload Phase B Inverter is operating with an overload on phase B
Inverter Overload Phase C Inverter is operating with an overload on phase C
Inverter Overload Time Remaining The calculated time remaining before inverter shutdown
Inverter Shutdown - Overload The in verter has shutdown due to a sustained overload
Inverter Static Switch SCR Short The system has detected a short across one or more inverter static switch
Silicon Controlled Rectifiers (SCR)
LBS Inhibited The system has detected that conditions to perform Load Bus Sync are
not satisfied
Leading Power Factor The leading output Power Factor has fallen below a specified value
Main Battery Disconnect Open Main battery disconnect is open
Main Controller Fault A Main Controller fault has been detected.
Maintenance Bypass Breaker (MBB) Maintenance bypass breaker (MBB)
Maintenance Isolation Breaker (MIB) Maintenance isolation breaker (MIB)
Module Output Breaker (MOB) Module output breaker (MOB)
Table 57 Liebert NXL™ - 60Hz, UL version (Model 40) - Glossary (continued)
Data Label Data Description