Household Stand Mixer
Speed Control
RESET
OFF/0STIR2 4 6 8 10
Plug into a grounded 3 prong outlet. Speed control lever should always be set on lowest speed for starting, then gradually moved to desired higher speed to avoid splashing ingredients out of bowl. See “Speed Control Guide -
Auto-Reset Motor Protection
If the stand mixer stops due to overload, slide the speed control lever to OFF. After a few minutes, the stand mixer will automatically reset. Slide the Speed Control Lever to the desired speed and continue mixing. If the stand mixer does not restart, see the “Troubleshooting” section.
Using the Pouring Shield
Attaching the Pouring Shield
1.Make sure the speed control lever is set to the OFF/0 position.
2.Unplug the stand mixer.
3.Attach desired accessory and raise the mixing bowl.
4.Slide pouring shield collar around beater shaft, centering collar over rim of bowl.
Using the Pouring Shield
Pour ingredients into the mixing bowl through the chute portion of shield.
IMPORTANT: Make sure the guides on the bottom of the chute rest on the rim of the bowl to keep ingredients from falling outside the bowl as they are added.
Pouring
Chute
Removing the Pouring Shield
1.Make sure the speed control lever is set to the OFF/0 position.
2.Unplug the stand mixer.
3.Remove pouring chute from collar.
4.Slide pouring shield collar off bowl.
5.Lower the bowl support by turning the
6.Remove accessory and the mixing bowl.
Cleaning the Pouring Shield
Wash in warm sudsy water. If you wish, you may place on the top rack of your dishwasher.
6
