Siemens 400 V / 210...590 A General parameters, P051 Access Level, P052 Function Select

Parameter List 01.2004

12.2General parameters

PNU		Parameter Name in OP1						Range	# of Indices	read:	_/_
								[Unit]	Factory	write:	_/_
*:conf-P		Description						Value Texts	Settings
P050		Language						0 to 5	−	2 /UHABR
*		Plain text display language on the optional OP operator panel							0	2 /UHABR
32Hex		and in the DriveMonitor PC program
		Parameter values:
		0: German
	1:		English					Deutsch
	2:		Spanish
								English
	3:		French
								Espanol
	4:		Italian
								Francais
		Type=O2;			PKW: 1HEX=1	PZD Gr.: -
								Italiano
P051		Access Level						1 to 3	−	1 /UHABR
*		Access level setting; the higher the access level, the more							2	1 /UHABR
33Hex		parameters can be accessed for reading and writing.
		Parameter values:
		1: Operation via PMU/ OP						Operation
	2:		Standard mode					Standard
	3:		Expert mode					Expert
		Type=O2;			PKW: 1HEX=1	PZD Gr.: -
P052		Function Select						0 to 20	−	2 /UHABR
*		Selection of various commissioning steps and special							0	2 /UHAB
34Hex		functions.
		Parameter values:
	0 =			Return to the previously active drive status from one of				Return
				the functions described below.
	1 =			Parameter Reset: All parameters are reset to their				Par. Reset
				original settings (factory settings). According to the
				Profibus profile for variable speed drives this function is
				also accessible via parameter P970. On completion of
				this function, the parameter is automatically reset to 0.
	2 =			Enable MLFB setting mode (switch to MLFB Input				Set MLFB
				operating status). The function can be deselected only
				by resetting the parameter to 0 (Return).
	3 =			Download/upread (switch to Download operating status).			Download
				The function can be deselected only by resetting the
				parameter to 0 (Return).
	4 =			Hardware configuration (switch to Hardware Settings				H/W Setting
				operating status). The function can be deselected only
				by resetting the parameter to 0 (Return).
	5 =			Closed-loop control settings (switch to Closed-Loop				Drive Setting
				Control Settings operating status to parameterize plant
				data). The parameter must be reset to 0 (Return) to exit
				the function without modifying parameters internally.				Capacitor
	20 =			Forming
		Type=O2;			PKW: 1HEX=1	PZD Gr.: -		forming

12-4	6SE7087-6CX86-2BA1 Siemens AG
	Operating Instructions SIMOVERT MASTERDRIVES AFE