Siemens 400 V / 210...590 A operating instructions 12-12

	Parameter List						01.2004
	PNU	Parameter Name in OP1			Range	# of Indices		read:		_/_
					[Unit]	Factory		write:		_/_
	*:conf-P	Description			Value Texts	Settings
	P173	Imax			1 to 30000	2		3 /	BR
		Maximum current (fundamental r.m.s.)			[A]	i001=←		3 /	BR
	ADHex	Setpoint for current limitation (Imax controller) to protect the				i002=←
		AFE.
		Maximum 1.36 x conv.current(n) (P072).
		Visualization parameters: r174: Actually applied maximum
			current setpoint (taking derating
			into account)
		Note: The maximum current set here must always be so
		high so that the AFE can handle the power
		demanded by the drive. If the drive demands more
		current than the maximum current set here, the AFE
		shuts down with the “overload” fault (F013).
		RDS(2) parameter
		Type=O2;	PKW: 1HEX=1 A	PZD Gr.: 6
	r174	Imax(set)				−		3 /	BR
		Maximum current (setpoint applied)			[A]
	AEHex	Setpoint applied for current limiting (Imax controller); takes into
		account the effect of the I²t calculation
		Note:	P173 (parameterized maximum current setpoint)
		Analog output: 100 % with code number (PWE) = 40 x P072
		Type=O2;	PKW: 1HEX=1 A	PZD Gr.: 6
r179		Output Amps (rms)				−		3 /	BR
B3Hex		Output current (fundamental rms) (fast actual value for			[A]
		automation purposes)
		Analog output: 100 % with code number (PWE) = 4*P072
		Type=O2;	PKW: 1HEX=0.1 A	PZD Gr.: 6
	r255	I (reactive,set)				−		3 /	BR
		Reactive current component setpoint.			[A]
	FFHex	Limited by the maximum current (r174) and the active current
		setpoint (r263).
		Analog output: 100 % with code number (PWE) = 4 x P072
		Type=I2;	PKW: 1HEX=0.1 A	PZD Gr.: 6
	r256	I (reactive,act)				−		3 /	BR
	100Hex	Actual value of reactive current component			[A]
		Analog output: 100 % with code number (PWE) = 4 x P072
		Type=I2;	PKW: 1HEX=0.1 A	PZD Gr.: 6
	r263	I (active,set)				−		3 /	BR
	107Hex	Setpoint of active current component.			[A]
		Limited by the maximum current (r174).
		Analog output: 100 % with code number (PWE) = 4 x P072
		Type=I2;	PKW: 1HEX=0.1 A	PZD Gr.: 6
	r264	I (active,act)				−		3 /	BR
	108Hex	Actual value of active current component			[A]
		Analog output: 100 % with code number (PWE) = 4 x P072
		Type=I2;	PKW: 1HEX=0.1 A	PZD Gr.: 6

12-12	6SE7087-6CX86-2BA1 Siemens AG
	Operating Instructions SIMOVERT MASTERDRIVES AFE