Siemens 400 V / 210...590 A Control terminals, Standard connections of the AFE inverter, Strip

Connecting-Up and Wiring 01.2004

7.3Control terminals

7.3.1Standard connections of the AFE inverter

	The basic version of the converter features the following control
	terminals on the CUSA board:
	♦ Control terminal strips X100, X101 and X102 on CUSA electronics
		board
	♦ Connection for OP1S operator control panel
	♦ One serial interface (USS bus, RS485)
	♦ Serial interfaces RS485 and RS232 (SCom1) on PMU X300
CAUTION
	The CUSA board contains components which can be destroyed by
	electrostatic discharge. These components can be very easily
	destroyed if not handled with caution.
	See also ESD precautions outlined in Section "Definitions and
	warnings".
Connectors for	The connectors for the control terminal strip are included in the scope
control terminal	of supply and ready connected to the cable harness of the AFE basic
strip	mains module (cf. Fig. 7-1).
	Cables with cross-sections from 0.14 mm2 to 1.5 mm2 (AWG: 26 to
	16), or 1 mm2 (AWG: 18) can be connected using stranded wire with
	lugs to the connectors (recommended: 0.5 mm2 (AWG: 20)). The
	connectors can be identified by the pin numbers (Table 7-5), connector
	positions on the board are shown in Fig. 7-8.
	Two screen clamps and four cable ties are required from the loose
	components supplied to connect the control cables.
	Connector X9 is needed to control the pre-charging operation and to
	connect an external power supply (see Fig. 7-8).
		Connector		Label
		X100	eight-pin, coded	1	2	3	CU	6	7	8
		X101	eight-pin, coded	13	14	15	CU	18	19	20
		X102	ten-pin	25	26	27	28	CU	31	32 33 34

Table 7-5

7-10	6SE7087-6CX86-2BA1 Siemens AG
	Operating Instructions SIMOVERT MASTERDRIVES AFE