Sony DVW-709WS/709WSP manual Installation Brush Assembly Installation, Brush Cover Installation

Installation

3. Brush Assembly Installation

(1)Temporarily attach the brush assembly to the brush support using the screw shown in the figure.

n

Never touch the brush.

(2)Move the brush base while pressing down the brush base above the brush support and tempo- rarily attach the brush assembly using the oth- er screw.

(3)Tighten the screws which are attached in steps

(1) and (2).

(4)Check that the brush touches against the slip ring.

n

Once steps (1) to (3) are completed, the height of the brush and contact pressure against the slip ring will be automatically adjust.

(5)Connect the connector on the brush assembly board.

	4-2. Parts Replacement
Brush base	P 2x4
Brush
Slip ring
	Temporarily
	attach this
	screw first.
	Brush support
Brush	Slip ring
Connector

4. Brush Cover Installation

Align the hole of the brush cover with the shaft of the slip ring and tighten the two screws.

DVW-790WS/709WS/707 4-19

DVW-790WSP/709WSP/707P P2V1