8-12 DVW-790WS/709WS/707
DVW-790WSP/709WSP/707P P2V1
8-10. Preset White Adjustment
Note
Only when changing the color temperature setting of preset
white (PRST), perform this adjustment.
Preparation
.OUTPUT/DCC switch (inside panel) → CAM/ON
.Shoot a white pattern of color temperature to suit the
customer’s preferences.
Adjustment Procedure
1. Equipment : Waveform monitor
Test point : TEST OUT connector
setting point : 1 Lens IRIS
Spec. : A = 90 ±2 IRE (NTSC)
A = 630 ±10 mV (PAL)
.On the setup menu, adjust as follows.
PAGE : S35*PRESET WHT
ITEM : COLOR TEMP <P>
ITEM : FINE <WHITEP>
ITEM : R GAIN <P>
ITEM : B GAIN <P>
Spec. : Adjust R GAIN and B GAIN alternate-
ly until the carrier leakage is not present
on the white pattern signal at any time.
8-11. Shading Adjustment

8-11-1. Black Shading Adjustment

Preparation
.Lens IRIS → CLOSE
.Waveform monitor setting
LUM mode
VOLT FULL SCALE range → 0.5
Adjustment Procedure
Equipment : Waveform monitor
Test point : TEST OUT connector
1. On the setup menu, set as follows.
PAGE : S48*B-SHADING G
ITEM : TEST OUT → G
2. Make the waveform to flat by rotary encoder according
to the table below.
3. Adjust the shading for R and B channels in the same
way.
TEST OUT H SAW V SAW H PARA V PARA
G S48*B-SHADING G
TEST OUT
→
G H SAW V SAW H PARA V PARA
<BG> <BG> <BG> <BG>
R S49*B-SHADING R
TEST OUT
→
R H SAW V SAW H PARA V PARA
<BR> <BR> <BR> <BR>
B S50*B-SHADING B
TEST OUT
→
B H SAW V SAW H PARA V PARA
<BB> <BB> <BB> <BB>
Setting After Adjustment
.On the setup menu, set as follows.
PAGE : S50*B-SHADING B
ITEM :TEST OUT → ENC
8-10. Preset White Adjustment
8-11. Shading Adjustment
(H SAW) (H PARA) (V SAW) (V PARA)