Sony DVW-790WS/790WSP Removal Manual Eject Assembly Removal, Mechanical Deck Assembly Removal

4-2. Parts Replacement

Removal

1.Manual Eject Assembly Removal

Remove the screw and the manual eject assembly. (Refer to section 4-1-3.)

2.Mechanical Deck Assembly Removal

(1) Remove the four screws shown in the figure

using the hexagon bit. n

These screws can not be removed due to the drop-safe.

(2)Lift up the ornamental bracket of the HN-260 board and disconnect the 100-pin connector that connects to the mother board at the bottom of the HN-260 board.

(3)While holding the shaded portion of the arm on the cassette compartment, or cassette guide, and HN-260 board shown in the figure, lift up and remove the mechanical deck assembly from the unit.

m

.When removing, take care not to scratch the vid- eo heads, drum and other parts.

.Never put the removed mechanical deck assem- bly to bottom side down or up side down on the desk.

.In the replacement, put the mechanical deck as- sembly as shown in the figure and carry out the following steps while holding it by hand.

100-pin connector
	HN-260 board
	Cassette guide	Screws (with
Cassette		drop-safe)
compartment
arm
Screws		Mechanical deck assembly
(with drop-safe)

4-58 DVW-790WS/709WS/707

DVW-790WSP/709WSP/707P P2V1