Sony DVW-709WS/709WSP, DVW-790WS/790WSP manual Spec 10.9 ± 0.2 us Ntsc 12.0 ± 0.3 us PAL

10. On the setup menu, adjust as follows.

PAGE	: S39*SG ADJ.
ITEM	: H BLANKING WIDTH
Spec.	: D =	10.9	± 0.2 us (NTSC)
	D =	12.0	± 0.3 us (PAL)

20 IRE (NTSC)	D
140 mV (PAL)

11. On the setup menu, adjust as follows. (For only NTSC)

PAGE	: S39*SG ADJ.
ITEM	: V BLANKING WIDTH
Spec.	: 20H or 21H

8-4. ENC OUT Adjustment

8-4-3. INT SC Phase Adjustment

Note

The following adjustment procedures are described under the condition by using the Tektronix 1750/1751. If any other measuring instrument is used, perform the adjust- ment according to the operation manual attached to it.

Preparation

.On the setup menu, set as follows.

PAGE		: S24*ELEVEL 7
ITEM		: TEST OUT → ENC
Adjustment Procedure
Equipment		: Waveform/Vector monitor
		(SC-H Phase measuring mode)
Test point		: TEST OUT connector
1. On the setup menu, adjust as follows.
PAGE		: S28*LEVEL 11
ITEM		: SC PHASE
Spec.		: Coincide the beam spot of the burst
		(SC) with the direction of the beam
		spot of H.
		MG
		R	R		MG
	YL		YL
		B			B
	G	CY	G	CY
	(For NTSC)		(For PAL)

Setting After Adjustment

A B

1

2

3

FL12

1

4

5

DVW-790WS/709WS/707

C

Connect the waveform monitor to the TEST OUT connec- tor.

D E F G

ES-23 board (A side)

8-7

DVW-790WSP/709WSP/707P P2V1