Sony DVW-709WS/709WSP Removal Required tool, Camera SW ornamental plate Mm or less Inside panel

Removal

Required tool

.Sealant TSE-392W : 7-432-950-03

1.Remove the remaining old sealant from the

surface of the inside panel ( portion in the figure) using a flatbrade screwdriver.

2.Reattach the camera SW ornamental plate to the inside panel using the two screws. Standard tightening torque :

15 x10_2 N.m {1.5 kgf.cm}

3.Apply a sufficient amount of sealant from through inside the inside panel until the hole

and the stud ( portion in the figure) are covered by the sealant.

4.Check that the clearance between the camera SW ornamental plate and the inside panel is 0.4 mm or less when checked from the outside.

5.Reattach the CP-329 board and the inside panel by reversing the removing steps.

DVW-790WS/709WS/707

3-6. Replacing the Camera SW Ornamental Plate

TP 2x4

Camera SW ornamenta plate

Hole of

the inside panle

Sealant

Stud of the camera SW ornamental plate

VTR	GAIN	OUTPUT WHITE BAL
OFF	CANCEL/PRST
ON
PAGE	ITEM	ASSIGNABLE
	MENU
POWER
ON	OFF

Camera SW ornamental plate

0.4 mm or less

Inside panel

3-27

DVW-790WSP/709WSP/707P P2V1