5-1. Tape Running Adjustment

Adjustments

8.S2, Tension Regulator and S5 Guides Height Adjustment

(1)Enter the PLAY mode at the tape top of ZR2- 1/P (from 5 minute to 10 minute segment).

(2)Loosen the set screws at the top of the guides using the tape guide adjustment screwdriver. Turn the upper flanges of the guides, and adjust the heights of the guides so that satisfy the specifications 1 to 3.

(3)Tighten the screws at the top of the guides.

9.Tape Running Re-check at the Drum Entrance Side

Perform from the steps 1 to 7 of the check procedures, and re-check that the specifications are satisfied.

If the specifications are not satisfied, perform step 8 again.

10.Tape Running Check at the Drum Exit Side.

Check the tape running at the drum exit side on the following page and later.

Checks After Adjustment

11.Video Tracking Check

Refer to section 5-2.

12.CTL Head Height Check

Refer to section 5-3.

13.CTL Head Position Check

Refer to section 5-4.

14.CUE/TC Head Position Check

Refer to section 5-8.

Tape guide adjustmnet screwdriver

Set screw

Upper flange

Tape guide

5-6

DVW-790WS/709WS/707

 

DVW-790WSP/709WSP/707P P2V1

Page 216
Image 216
Sony DVW-790WS/790WSP manual Tape Running Re-check at the Drum Entrance Side, Tape Running Check at the Drum Exit Side