5-2. Video Tracking Adjustment

5-2. Video Tracking Adjustment

Notes

.Tighten the screws at the top of the tape guides to the following tightening torque. 9 x10_2N.m (0.9 kgf.cm)

.After this adjustment, be sure to check the tape running adjustment.

After checking, put a locking compound to the screws at the top of each tape guide.

Tools

 

.Tape guide adjustment screwdriver (45)

: J-6322-420-B

.Inspection mirror

: J-6080-840-A

.TP tool

: J-6420-910-A

.Alignment tape, ZR2-1 (NTSC)

: 8-960-073-11

.Alignment tape, ZR2-1P (PAL)

: 8-960-073-61

.Oscilloscope

 

Setting

1.Turn the power off.

2.Connect the 8-pin connector of the TP tool to the connector CN7 on the HN-260 board.

3.Connect the 5-pin connector of the TP tool to the connector CN3 on the CTL-10 board.

4.Set the all four switches of switches S1 and S2 on the UDR-9 board which is attached to the upper drum to TEST (ON).

5.Set the switch S4 on the HN-260 board to TEST.

6.Disconnect the connector that comes from the slip ring and connect the connector of the harness to CN9 on the HN-260 board.

7.Set the switches S1-1 and S1-2 on the HN- 260 board to OFF.

8.Connect an oscilloscope. CH-1 : REC RF A/TP tool CH-2 : REC RF E/TP tool TRIG : SV REF CF/TP tool

9.Turn the power on.

10.Insert the alignment tape cassette ZR2-1P.

Switch S4

HN-260 board

 

Switch S1

Switch S1

 

Drum assembly

 

Switch S2

UDR-9 board

DVW-790WS/709WS/707

5-11

DVW-790WSP/709WSP/707P P2V1

 

Page 220 Page 222
Page 221
Image 221
Sony DVW-709WS/709WSP, DVW-790WS/790WSP manual Video Tracking Adjustment, Tools
Page 220 Page 222
Top Page Image Contents