Sony DVW-790WS/790WSP, DVW-709WS/709WSP manual Spec = 100 ± 2 IRE Ntsc = 700 ± 14 mV PAL

8-5. TEST OUT Level Adjustment

8-6. Modulator Balance Adjustment

8-5. TEST OUT Level Adjustment

Preparation

.OUTPUT/DCC switch (inside panel) → BARS

.On the setup menu, set as follows.

PAGE	: S23*LEVEL 6
ITEM	: TEST OUT → R, G or B
Adjustment Procedure
Equipment	: Waveform monitor
Test point	: TEST OUT connector
1. On the setup menu, adjust as follows.
PAGE	: S23*LEVEL 6
ITEM	: RGB SYNC
Spec.	: A = 40 ± 2 IRE (NTSC)
	A = 300 ± 14 mV (PAL)
2. On the setup menu, adjust as follows.
PAGE	: S23*LEVEL 6
ITEM	: RGB SETUP
Spec.	: B = 7.5 ± 0.5 IRE (NTSC)
	B = 0 ± 3 mV (PAL)
3. On the setup menu, adjust as follows.
PAGE	: S23*LEVEL 6
ITEM	: RGB LEVEL
Spec.	: C = 100 ± 2 IRE (NTSC)
	C = 700 ± 14 mV (PAL)
NTSC	PAL

R	R
C	C
B	B
	A
A

Setting After Adjustment

.On the setup menu, set as follows.

PAGE	: S23*LEVEL 6
ITEM	: TEST OUT → ENC

8-6. Modulator Balance Adjustment

Preparation

.WHITE BAL switch (inside panel) → PRST

.OUTPUT/DCC switch (inside panel) → CAM/ON

.MENU ON/OFF/PAGE switch (inside panel) → OFF

Adjustment Procedure

1.AUTO W/B BAL switch (front panel) → BLK Hold this switch in BLK state untilthe message “ _MOD BAL_” on the viewfinder is displayed .

2.A few seconds later after releasing the switch, check that the message “BLACK OK” is displayed on the viewfinder.

8-8 DVW-790WS/709WS/707

DVW-790WSP/709WSP/707P P2V1