Sony DVW-709WS/709WSP, DVW-790WS/790WSP manual Installation CUE Head Replacement, CN2

Installation

5. CUE Head Replacement

(1)Disconnect the connector CN2 on the CUE-2 board.

(2)Remove the screw and open the CUE-2 board.

(3)Remove the two screws at the top of the CUE head block and the CUE head.

In this way the shield case and the adjustment plate (R) are removed.

(4)Desolder the four leads from the printed circuit board of the CUE head, and re-solder them to the new CUE head.

n

Never mistake the soldering positions.

(5)After putting the new CUE head in the shield case, assemble the parts in the sequence shown in the figure and tighten the two screws.

(6)Attach the CUE-2 board using the two screws.

(7)Connect the harness connector from the CUE head to the connector CN2 on the CUE-2 board.

4-2. Parts Replacement

PWH 1.4x2.5

CUE-2 board

CN2

PSW 2x5

CUE head

Adjustment plate (R)

Lead wire (red)	2P	Shield case
	connector
	(to CN2)

Lead wire (gray)

CUE headLead wire (red)

Lead wire (gray)

3P connector (to CN12)

DVW-790WS/709WS/707 4-69

DVW-790WSP/709WSP/707P P2V1