Sony DVW-709WS/709WSP, DVW-790WS/790WSP manual 169/43 Mode → Select the 43 mode

7-17. Detail Signal Adjustment (4:3)

7-17. Detail Signal Adjustment (4:3)

7-17-1. Crispening Adjustment (4:3)

4:3 mode

Preparation

.On the setup menu, set as follows.

PAGE	: S12*FUNCTION 1/2
ITEM	: DETAIL → ON

.OUTPUT/DCC switch (inside panel) → CAM/ON

.Shoot a grayscale chart (4:3) in the full underscanned monitor frame.

Equipment	: Waveform monitor
Test point	: TEST OUT connector
Setting point	: 1Lens IRIS
Spec.	: A = 100	±2 IRE (NTSC)
	A = 700	±14 mV (PAL)

A

Adjustment Procedure

7-17-2. Level Depandent Adjustment (4:3)

4:3 mode

Preparation

.On the setup menu, set as follows.

PAGE	: S12*FUNCTION 1/2
ITEM	: DETAIL	→ ON
ITEM	: TEST OUT	→ ENC
PAGE	: S18*LEVEL 1#4:3
ITEM	: LVL DEPEND <4:3> → ON

.OUTPUT/DCC switch (inside panel) → CAM/ON

.Shoot a grayscale chart (4:3) in the full underscanned

monitor frame.
Equipment	: Waveform monitor
Test point	: TEST OUT connector
Setting point	: 1Lens IRIS
Spec.	: A = 100	±2 IRE (NTSC)
	A = 700	±14 mV (PAL)

A

Equipment	: Black and white monitor	Adjustment Procedure
Test point	: TEST OUT connector
		Equipment	: Waveform monitor
1. Select the 4:3 mode.		Test point	: TEST OUT connector
PAGE	: S14*WIDE SCREEN
ITEM	: 16:9/4:3 MODE → 4:3	1. Select the 4:3 mode.
		PAGE	: S14*WIDE SCREEN
2. On the setup menu, adjust as follows.		ITEM	: 16:9/4:3 MODE → 4:3
PAGE	: S18*LEVEL 1#4:3
ITEM	: CRISPENING <4:3>	2. On the setup menu, adjust as follows.
Spec.	: Reduce the noise at gray portion to a	PAGE	: S18*LEVEL 1#4:3
	permissible level.	ITEM	: L.DEP.LVL <4:3>
		Spec.	: Eliminate the detail signal from portion
			B.

B

Note

After this adjustment, be sure to perform Section 7-17-4 “H/V Ratio Adjustment (4:3)”, and Section 7-17-5 “Detail Level Adjustment (4:3)”, in that order.

DVW-790WS/709WS/707 7-27

DVW-790WSP/709WSP/707P P2V1