Sony DVW-790WS/790WSP, DVW-709WS/709WSP manual Motor Installation, Gear Block Assembly Installation

4-2. Parts Replacement

7. Motor Installation

Attach the motor unsig the two screws. The standard tightening torque value :

21x10_2 N.m {2.1 kgf.cm}

8.Gear Block Assembly Installation

(1)While connecting the connector of the tape top sensor theat connects to the rear block assem- bly to the connector on the SE-275 board which is attached to the chassis, put the pin of the chassis in the longitudinal hole of the gear block assembly and the top of the joint gear that is attached to the chassis in the round hole of the gear block assembly. Tighten the three

screws.

The standard tightening torque value :

9x10_2 N.m {0.9 kgf.cm}

(2)Connect the harness connector to the connec- tor CN3 on the CUE-2 board.

9.Cassette Compartment Installation

Attach the cassette compartment using the three screws. (Refer to section 1-8 of Maintenance Man- ual Part 1.)

The standard tightening torque value :

9 x10_2 N.m {0.9 kgf.cm}

4-106

PWH 1.4x2.5

Round hole Longitudinal hole

Connector

(Tape top sensor)

CUE-2 board

CN3

Pin (chassis)

Joint gear

Connector (SE-210 board)

DVW-790WS/709WS/707 P2V1

DVW-790WSP/709WSP/707P P2V1