2.Mechanical Deck Assembly Removal

(1) Remove the four screws shown in the figure

using the hexagon bit.

n

These screws can not be removed due to the drop-safe.

(2)Lift up the ornamental bracket of the HN-260 board and disconnect the 100-pin connector that connects to the mother board at the bottom of the HN-260 board.

(3)While holding the shaded portion of the arm on the cassette compartment, or cassette guide, and HN-260 board shown in the figure, lift up and remove the mechanical deck assembly from the unit.

m

.When removing, take care not to scratch the vid- eo heads, drum and other parts.

.Never put the removed mechanical deck assem- bly to bottom side down or up side down on the desk.

.In the replacement, put the mechanical deck as- sembly as shown in the figure and carry out the following steps while holding it by hand.

DVW-790WS/709WS/707

4-2. Parts Replacement

100-pin connector

HN-260 board

Cassette guide

 

Cassette

Screws

compartment

(with drop-safe)

arm

 

Screws (with drop-safe)

Mechanical deck

 

assembly

4-49

DVW-790WSP/709WSP/707P P2V1

Page 133
Image 133
Sony DVW-709WS/709WSP, DVW-790WS/790WSP manual Mechanical Deck Assembly Removal