Sony DVW-709WS/709WSP manual REV Mode Rewind at tape end, FWD Mode Fast forward at tape end

5. REV Mode (Rewind at tape end)

(1)Set the dip switch S1-1 on the HN-260 board to ON.

The red LED will light up.

(2)Press the switch S3 on the HN-260 board 10 times. After pressing, check that the Nos. 1 and 3 of the MODE display LEDs light up.

(3)Enter the PLAY mode at the tape end of BCT-D40 (from 30 minute to 40 minute segment).

After 2 or 3 seconds, press the REW button. This setting enables the unit to enter the REVx1 mode.

Check that the tape running conditions satisfy the specifications 2 at the tension regulator and S5 guides.

If the specifications 2 is not satisfied, perform step 8 and higher.

(4)Set the dip switch S1-1 on the HN-260 board to OFF.

The red LED will be turned off.

6.F FWD Mode

(Fast forward at tape end)

Enter the F FWD mode at the tape end of BCT- D40 (from 30 minute to 40 minute segment). Check that the tape running conditions satisfy the specifications 3.

If the specifications 3 is not satisfied, perform step 8 and higher.

7. REW Mode (Rewind at tape end)

Enter the REW mode at the tape end of BCT-D40 (from 30 minute to 40 minute segment). Check that the tape running conditions satisfy the specifications 3.

If the specifications 3 is not satisfied, perform step 8 and higher.

5-1. Tape Running Adjustment

Specifications 2:

(A)Upper flange of the S2 guide Tape runs without any curl.

If tape curl occurs by all means, 1/10 or less of a tape width is acceptable.

(B)Upper or lower flange of the tension regulator guide Tape runs without any curl.

If tape curl occurs by all means, 1/10 or less of a tape width is acceptable.

(C)Upper or lower flange of the S5 guide Tape runs without any curl.

If tape curl occurs by all means, 1/10 or less of a tape width is acceptable.

(D)Drum lead

Tape runs in contact with the drum lead and without any curl.

Specifications 3:

(A)Upper flange of the S2 guide Tape runs without any curl.

If tape curl occurs by all means, 1/10 or less of a tape width is acceptable.

(B)Upper or lower flange of the tension regulator guide Tape runs without any curl.

If tape curl occurs by all means, 1/10 or less of a tape width is acceptable.

(C)Upper or lower flange of the S5 guide Tape runs without any curl.

If tape curl occurs by all means, 1/10 or less of a tape width is acceptable.

DVW-790WS/709WS/707	5-5
DVW-790WSP/709WSP/707P P2V1