Sony DVW-709WS/709WSP, DVW-790WS/790WSP manual Manual Eject Assembly Removal/Installation

4-1-3. Manual Eject Assembly Removal/Installation

Removal

(1)Turn the power off.

(2)Remove the front lid and the outside panel. (Refer to section 1-6 of Maintenance Manual Part 1.)

(3)Remove the screw and the manual eject as- sembly.

Installation

(1)Pass the big hole of the manual eject assembly through the capstan shaft.

(2)Tighten the screw.

(3)While pressing down the knob of the manual eject assembly, turn it in the direction or re- verse direction of the arrow. When turning it, check that the gears correctly engage and turn.

4-1. General Information for Parts Replacement and Adjustment

Manual eject assembly

Screw (PWH 1.4x2.5)

Capstan shaft

Positioning pin

m

.After the cassette compartment raised up, do not keep on turning the manual eject knob counter- clockwise.

If keep on turning it, the component parts of the unit will break.

When the marking on the cam is at position shown in the figure, never turn the manual eject knob counterclockwise.

.When closing the front lid after using the manual eject knob, be sure to turn the power on.

Cam

Intermittent

gear

Manual eject

knob

Mark

Cassette

compartment

(unthreading mode)

DVW-790WS/709WS/707 4-3

DVW-790WSP/709WSP/707P P2V1