Sony DVW-709WS/709WSP, DVW-790WS/790WSP manual Reinstallation, Adjustment After Replacement, CN3

3-2-2. Replacing the Filter Disk Unit (DVW-790WS/790WSP/709WS/ 709WSP only)

m

.The filter disk unit used in the DVW-707/707P cannot be removed because it is built into a single body with the CCD unit.

.Be sure to replace the filter disk unit in a dust- free atmosphere such as a clean room.

Removal

1.Remove the CCD unit. (Refer to Section 3-2-1.)

2.Remove the two screws and disconnect the harness from the connector (CN3) on the DR- 387 board, and then slowly lift the filter disk unit out.

Reinstallation

1.Reinstall the new filter disk unit using the two screws removed in step 2 of the removal procedure. And then reconnect the harness of the filter disk unit to the connector (CN3) on the DR-387 board.

n

Do not contact the surface of the filter disk unit during installation.

2.Reinstall the CCD unit on the front frame assembly using the four hexagon socket bolts. Standard tightening torque :

80x10_2 N.m {8 kgf.cm}

3.Reinstall the CCD unit. (Refer to Section 3-2-1.)

Adjustment After Replacement

Adjustment after Filter Disk Unit Replacement (Refer to Section 7-21*1or 8-20*2.)

*1: For DVW-790WS/790WSP/709WS/709WSP only

*2: DVW-707/707P only

DVW-790WS/709WS/707

3-2. Replacing the CCD Unit and Its Components

Filter disk unit

CN3

K 3x6

DR-387 board

3-13

DVW-790WSP/709WSP/707P P2V1