Sony DVW-709WS/709WSP, DVW-790WS/790WSP manual Detail Level Adjustment

8-16-5. Detail Level Adjustment

Note

Perform this adjustment, if necessary, to suit the custom- er’s preferences.

Preparation

. On the setup menu, set as follows.

PAGE	: S12*FUNCTION 1/2
ITEM	: DETAIL → ON
ITEM	: TEST OUT → ENC

.Shoot a grayscale chart in the full underscanned monitor frame.

Equipment	: Waveform monitor
Test point	: TEST OUT connector
Setting point	: 1Lens IRIS
Spec.	: A = 80 ± 2 IRE (NTSC)
		A = 560 ± 14 mV (PAL)
			A

Adjustment Procedure

Equipment	: Waveform monitor
Test point	: TEST OUT connector
1. On the setup menu, adjust as follows.
PAGE	: S16*LEVEL 1
ITEM	: DETAIL LVL (Factory setting : 0)
Spec.	: Adjust to the detail amount which is added
	to each step in the grayscale chart for the
	customer’s preferences.

8-16. Detail Signal Adjustment

8-16-6. Knee Aperture Adjustment

Note

Perform this adjustment, if necessary, to suit the custom- er’s preferences.

Preparation

.On the setup menu, set as follows.

PAGE	: S12*FUNCTION 1/2
ITEM	: DETAIL	→ ON
ITEM	: TEST OUT	→ ENC
PAGE	: S17*LEVEL 2
ITEM	: KNEE APT.	→ ON

.OUTPUT/DCC switch (inside panel) → CAM/ON

.Shoot a grayscale chart in the full underscanned monitor frame.

Equipment	: Waveform monitor
Setting point	: 1Lens IRIS
Spec.	: A = 100	± 2 IRE (NTSC)
	A = 700	± 14 mV (PAL)

A

.GAIN switch (inside panel) → M (9 dB)

Adjustment Procedure

Equipment	: Waveform monitor
Test point	: TEST OUT connector
1. On the setup menu, adjust as follows.
PAGE	: S17*LEVEL 2
ITEM	: K.APT.LVL
Spec.	: Adjust the peak-to-peak level of the
	noise at the third steps from the top
	(portion B) in the grayscale chart, as
	desired. (Reference level is 40 mV)

B

DVW-790WS/709WS/707 8-21

DVW-790WSP/709WSP/707P P2V1