Sony DVW-790WS/790WSP, DVW-709WS/709WSP manual 16-4. H/V Ratio Adjustment

1. On the setup menu, adjust as follows.

PAGE : S16*LEVEL 1

ITEM : DTL FREQ. (Factory setting: 0)

Spec. : Set the desired width at the edge of portion B.

B

Note

After this adjustment, be sure to perform Section 8-16-4 “H/V Ratio Adjustment”, and Section 8-16-5 “Detail Level Adjustment”, in that order.

8-20

Equipment Test point

: Waveform monitor

: TEST OUT connector

A

. Select the line at the center white portion of the gray- scale chart.

Adjustment Procedure

: Waveform monitor

: TEST OUT connector

: 1Lens IRIS

: A = 100 ± 2 IRE (NTSC) A = 700 ± 14 mV (PAL)

.

.

On the setup menu, set as follows.

PAGE : S12*FUNCTION 1/2

ITEM: DETAIL → ON

ITEM: TEST OUT → ENC OUTPUT/DCC switch (inside panel) → CAM/ON Shoot a grayscale chart in the full underscanned monitor frame.

Equipment Test point Setting point Spec.

.

8-16. Detail Signal Adjustment

8-16-3. Detail Frequency Adjustment

Note

Perform this adjustment, if necessary, to suit the custom- er’s preferences.

Preparation

8-16-4. H/V Ratio Adjustment

Preparation

.On the setup menu, set as follows.

PAGE	: S12*FUNCTION 1/2
ITEM	: DETAIL → ON
ITEM	: TEST OUT → ENC

.OUTPUT/DCC switch (inside panel) → CAM/ON

.Shoot a grayscale chart in the full underscanned monitor frame.

Equipment	: Waveform montior
Test point	: TEST OUT connector
Setting point	: 1Lens IRIS
Spec.	: A = 100	± 2 IRE (NTSC)
	A = 700	± 14 mV (PAL)

A

Adjustment Procedure

Equipment	: Black and white monitor
Test point	: TEST OUT connector
1. On the setup menu, adjust as follows.
PAGE	: S16*LEVEL 1
ITEM	: H/V RATIO
Spec.	: Adjust so that the H and V detail amounts
	which are added are equivalent.

H

V

DVW-790WS/709WS/707

DVW-790WSP/709WSP/707P P2V1