Sony DVW-709WS/709WSP Reinstallation Reinstalling the CCD Unit, Reinstalling the ND Filter Knob

3-2. Replacing the CCD Unit and Its Components

Reinstallation

5. Reinstalling the CCD Unit

(1)Clean the area ( portion in the figure) of the CCD unit, that contacts the front frame.

(2)Reinstall the CCD unit on the front frame assembly using the four screws. Standard tightening torque :

80x10_2 N.m {8 kgf.cm}

6.Reinstalling the CC Filter Knob (DVW-790WS/790WSP/709WS/709WSP)

(1)Turn the lever in the direction of the “Re- moval” arrow to remove the mount cap. n

Exercise care to avoid contacting with the filter surface after removing the mount cap.

(2)Rotate the thick knob axis until the cross filter (grid patterned filter) can be seen when viewed from the outside front.

(3)Align the CC filter knob number “A” with the marking on the front panel as shown, and then tighten the two setscrews.

Standard tightening torque:

20 x10_2 N.m {2.0 kgf.cm}

(4)Rotate the CC filter knob and check that the knob rotates smoothly.

7. Reinstalling the ND Filter Knob

(1)Rotate the thin knob axis until the most light- colored filter can be seen when viewed from the outside front.

(2)Align the number “1” of the ND filter knob or the filter knob with the marking on the front panel, and then tighten the two set- screws.

Standard tightening torque (DVW-790WS/790WSP/709WS/709WSP) Two screws : 20 x10_2 N.m {2.0 kgf.cm} (DVW-707/707P)

Single screw : 53 x10_2 N.m {5.4 kgf.cm}

(3)Rotate the ND filter knob or the filter knob to check that the knob rotates smoothly.

(4)Turn the lever in the direction of the “Instal- lation” arrow, and then reinstall the mount cap.

DVW-790WS/709WS/707

CCD unit

Mount cap

	Lever
Cleaning	Removal
	Installation
DVW-790WS/709WS
	Setscrews (A)
Setscrews (B)	(WP 2x3)
(WP 2x3)
Thin knob axis
	1 A
Thick knob axis
ND filter knob	Mark
CC filter knob
Front panel
DVW-707
Setscrew (WP 3x3)
Filter knob
1
Number 1	Mark
	3-11

DVW-790WSP/709WSP/707P P2V1