Sony DVW-790WS/790WSP, DVW-709WS/709WSP manual Replacing the HN-260 Board

3-1. Replacing Boards

3-1-3. Replacing the HN-260 Board

1.Remove the outside panel.

2.Remove the mechanical deck assembly. (Refer to Section “4. Mechanical Deck Parts Replacement”.)

3.Untie the harnesses from the three coating lead pins.

4.Disconnect the harnesses from the ten connectors (CN1, CN2, CN4 to CN6, CN8, CN10, CN12, CN14 and CN21) on the HN- 260 board to remove the board.

n

It is difficult to remove these harnesses in the narrow clearance between the mechanical deck assembly and the HN-260 board.

Be careful to untie the harnesses from the respective coating lead pins one after another.

CN4	HN-260 board
	CN1
CN5
	CN8
	CN2
	CN10
	CN12
CN6	CN14
	CN21
	Coating lead pins

5.Reinstall the HN-260 board by reversing the removing steps.

n

Check that the bending portion of the HN holder of the mechanical deck assembly is put in the square hole of the reinforcement bracket attached to the HN-260 board.

	HN holder
Square hole	Reinforcement
	bracket
	HN-260 board
HN holder

3-4 DVW-790WS/709WS/707

DVW-790WSP/709WSP/707P P2V1