Under ‘Set Line Hunt Group’, select the lines you wish to add to the Hunt Group by checking the box next to the line.

Note: If multiple TalkSwitch units are connected to the LAN, a check box is enabled, so that outbound calls always hunt the lines on the unit where the extension is connected. This minimizes network traffic between units.

2.3.3.7Automatic Route Selection and Toll Restriction

Automatic Route Selection (ARS) allows outgoing calls to be redirected to different telephone lines or VoIP trunks and hence network operators based on the leading digits dialed to access geographical areas, mobile operators or services. For example, use this feature to block all long distance calls or redirect long distance calls to VoIP.

Toll Restriction allows calls to be blocked based on the geographical area code, mobile operator, service number or access code dialed.

The Automatic Route Selection (ARS) table is programmed by the system administrator with the leading digits of calls to be re-routed or blocked. TalkSwitch routes outgoing calls through Line Hunt Groups to telephone lines or VoIP trunks, dialing the outgoing Line Hunt Group access codes “9” or “81” to “88” or directly when Direct Line access is enabled on an extension. When ARS is activated for any Line Hunt Group and the caller has dialed, their dialed digits are compared to the leading digit entries in the Automatic Route Selection (ARS) table.

T A L K S W I T C H C O N F I G U R A T I O N

3 3

Page 41
Image 41
Talkswitch CT.TS005.001101.UK manual Automatic Route Selection and Toll Restriction