set the normal setting for the country or telephone company. It is recommended that extension telephone sets with Recall, R, or Flash buttons are used, to ensure the correct signal duration is sent. Do to mix telephone sets on the same system with different settings for Recall or Flash.
Accepted Recall (Flash) length settings will set the minimum and maximum duration accepted from an extension. Any disconnect signal from an extension telephone set longer than the maximum will be treated as if the extension has
Transmitted Recall (Flash) length: Must be set to the signal duration required by the telephone company. This signal is only used with the telephone company Three Way Calling/Conference feature.
Double Recall time
When two recalls are detected, TalkSwitch needs to calculate the time between the recalls to establish if they were intended to propagate a recall at the Telephone Exchange or to place a call on hold and then quickly retrieve it. The Double Recall time values signify the maximum time between two recalls that TalkSwitch recognizes as an intended recall to the Telephone Exchange. When two recalles are detected with a time gap larger than the value displayed, no recall is propagated at the Telephone Exchange. The value can be adjusted from 200 ms to 2000 ms with the default set at 1200 ms.
3-Way Calling wait time
This option adjusts the time required between recall hook and a dial string. Some telephone company
Ring Patterns
Click the ‘Check Ring Pattern...’ button and call any extension. After three rings the sequence of the ring pattern displays in a new window. The time is displyed in milliseconds.
Non-detection of disconnect-clear
This option controls the length of time after which TalkSwitch “drops” a line when silence is heard. This safeguard is useful when a telephone line does not send out the
T A L K S W I T C H C O N F I G U R A T I O N | 8 3 |
