<Installing Procedure>
(1)Assemble the Laser unit with the four Scanner holders and seven cup S M3x6 SR Taptite screws.
Note:
When assembling the Laser unit with the Scanner holders, ensure to put the positioning boss of the Laser unit into the positioning hole referring to the figure below.
Taptite, cup S M3x6 SR
Taptite, cup S M3x6 SR
Taptite, cup S M3x6 SR
Scanner holder Positioning boss
Scanner holder
Scanner holder
Laser unit
Positioning boss
Taptite, cup S M3x6 SR
Scanner holder
Frame unit
Positioning hole
Positioning hole | <Front> |
Fig.
(2)Connect the two flat cables (CN1, CN4) and one connector (CN8) into the Laser unit.
Note:
When connecting the flat cable(s), do not insert it at an angle. After insertion, check that the cable is not at an angle.
Laser unit
<Front>
Fig.
Confidential |