(1)Remove the two cup B M4x12 Taptite screws and two cup S M4x8 Taptite screws.
(2)Release the one Hook on the front side, two Hooks on the bottom and the two Hooks on the back side, and then remove the Side cover R ASSY.
Note:
When removing the Side cover R ASSY, be careful not to damage section “A”.
Taptite, cup S M4x8
Hooks
2a
Side cover R ASSY
2b
“A”Hook 
Taptite, cup S M4x8
<Right side>
Hooks
Taptite, cup B M4x12
(Tightening torque: 1.20 ±0.1 N m) *1
Fig.
*1 Tightening Note:
When tightening the screw, slowly turn it counterclockwise (in the direction to loosen the screw) with your hand until you feel that the screw is a little dropped in the hole. Then, slightly turn it clockwise (in the direction to tighten the screw) with your hand and tighten it according to the specified torque with a screwdriver.
Confidential |