(2)Remove the bind B M3x8 Taptite screw, and then remove the Toner sensor PCB ASSY K (TE/NEW) from the Frame unit.
(3)Remove the cup B M3x8 Taptite screw, and then remove the TE protect film 2 and Toner sensor PCB ASSY Y (TE/NEW) from the Frame unit.
(4)Remove the bind B M3x8 Taptite screw, and then remove the Toner sensor PCB ASSY M (TE/NEW) from the Frame unit.
(5)Remove the bind B M3x8 Taptite screw, and then remove the Toner sensor PCB ASSY C (TE/NEW) from the Frame unit.
Frame unit
<Left side>
Toner sensor PCB ASSY C (TE/NEW)
Taptite, bind B M3X8 (Tightening torque: 0.55 ±0.05 N m) *1
Taptite, bind B M3X8
(Tightening torque: 0.55 ±0.05 N m) *1
Toner sensor PCB ASSY M (TE/NEW)
Taptite, cup B M3X8
(Tightening torque: 0.55 ±0.05 N m) *1
TE protect film 2
Toner sensor PCB ASSY Y (TE/NEW)
Toner sensor PCB
ASSY K (TE/NEW)
Taptite, bind B M3X8
(Tightening torque: 0.55 ±0.05 N m) *1
Fig.
*1 Tightening Note:
When tightening the screw, slowly turn it counterclockwise (in the direction to loosen the screw) with your hand until you feel that the screw is a little dropped in the hole. Then, slightly turn it clockwise (in the direction to tighten the screw) with your hand and tighten it according to the specified torque with a screwdriver.
Confidential |