(1)Remove the cup S M3x6 Taptite screw and two bind B M4x12 Taptite screws, and then release the four Hooks to remove the Charge HVPS PCB ASSY from the Frame unit.
Hooks
Frame unit
<Right side>
Hook
Taptite, bind B M4x12 (Tightening torque: 1.20
±0.1 N m) *1
Positioning pin
Taptite, cup S M3x6
Charge HVPS PCB ASSY
Taptite, bind B M4x12
(Tightening torque: 1.20 ±0.1 N m) *1
Fig.
*1 Tightening Note:
When tightening the screw, slowly turn it counterclockwise (in the direction to loosen the screw) with your hand until you feel that the screw is a little dropped in the hole. Then, slightly turn it clockwise (in the direction to tighten the screw) with your hand and tighten it according to the specified torque with a screwdriver.
(2)Disconnect the eight connectors and flat cable from the Charge HVPS PCB ASSY.
Note:
-When disconnecting the connectors, they may be damaged if pulling the Charge HVPS PCB ASSY by force.
-After disconnecting the flat cable(s), check that each cable is not damaged at its end or
-When connecting the flat cable(s), do not insert it at an angle. After insertion, check that the cable is not at an angle.
Charge HVPS PCB ASSY
CN5 | CN6 | CN7 |
CN8
CN4
CN9
CN3
CN1
CN2
Fig.
Confidential |