(3)Remove the Screw pan (S/P washer) M4x8, and then remove the Ground terminal.
(4)Remove the two Taptite, flat B M3x10, and then remove the Power inlet socket from the Frame unit.
Taptite, flat B M3x10 (Tightening torque: 0.60 ±0.1 N m) *1
Frame unit
<Back side>
Power inlet socket | Screw pan | Ground terminal |
| ||
| (S/P washer) M4x8 |
|
Fig.
(5)Remove the three bind B M4x12 Taptite screws, and then release the Hook to remove the PS PCB unit from the Frame unit.
Hook | Frame unit |
|
PS PCB unit
<Right side>
Taptite, bind B M4x12
(Tightening torque: 0.90 ±0.1 N m) *1
Fig.
*1 Tightening Note:
When tightening the screw, slowly turn it counterclockwise (in the direction to loosen the screw) with your hand until you feel that the screw is a little dropped in the hole. Then, slightly turn it clockwise (in the direction to tighten the screw) with your hand and tighten it according to the specified torque with a screwdriver.
Confidential |