(1)Remove the cup S M3x6 Taptite screw and bind B M4x12 Taptite screw, and then remove the Ground plate.
(2)Remove the two cup S M3x6 Taptite screws, and then remove the Ground spring plate.
Ground spring plate
Taptite, cup S M3x6
Frame unit
Taptite, cup S M3x6
Taptite, bind B M4x12
(Tightening torque: 1.20 ±0.1 N m) *1
Ground plate
<Left side>
Main PCB ASSY
Fig.
*1 Tightening Note:
When tightening the screw, slowly turn it counterclockwise (in the direction to loosen the screw) with your hand until you feel that the screw is a little dropped in the hole. Then, slightly turn it clockwise (in the direction to tighten the screw) with your hand and tighten it according to the specified torque with a screwdriver.
(3)Disconnect all the connectors from the Main PCB ASSY.
Note:
-After disconnecting the flat cable(s), check that each cable is not damaged at its end or
-When connecting the flat cable(s), do not insert it at an angle. After insertion, check that the cable is not at an angle.
CN16 | CN14 CN10 CN7 |
| Main PCB ASSY | ||
CN17 |
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
| CN8 |
|
| |
|
|
| CN1 |
|
|
CN19 |
|
| CN2 |
|
|
|
|
| CN3 |
|
|
|
|
| CN4 |
|
|
|
|
|
|
| |
|
|
|
|
|
|
CN21
CN5
CN15 CN13 CN12
Fig.
Confidential |