Selector No. | Function |
| Setting and Specifications | ||
|
|
|
|
| |
|
| No. 1 | 2 | 3 | |
|
| 0 | 0 | 0: Invalid | |
1 | Prevention of line interrupt | 0 | 0 | 1: 10 % | |
0 | 1 | 0: 20 % | |||
during ICM recording (ratio of | |||||
guard tone response time to call | 0 | 1 | 1: 30 % (Default) | ||
3 | end tone ON time) | 1 | 0 | 0: 40 % | |
(Not used.) | |||||
| 1 | 0 | 1: 50 % | ||
|
| ||||
|
| 1 | 1 | 0: 60 % | |
|
| 1 | 1 | 1: 70 % | |
|
|
|
|
| |
4 |
|
|
|
| |
Not used. |
|
|
| ||
7 |
|
|
|
| |
|
|
|
|
| |
8 | Improvement of DTMF | 0: OFF | 1: ON | ||
detecting function | |||||
|
|
|
| ||
|
|
|
|
| |
Note:
Selectors 1 through 3 are applicable only to models equipped with
-Selectors 1 through 3: Prevention of line interrupt during ICM recording (ratio of guard tone response time to call end tone ON time) (Not used.)
If an ICM tone is detected as a call end tone by error, this machine will release the line even during ICM recording. To avoid this problem, change the setting for the ratio of guard tone response time to the call end tone ON detection time.
If the actual percentage of guard tone response time is greater than the percentage set by selectors 1 through 3, this machine will judge that the call end tone has not yet been detected and will continue ICM recording.
< WSW59 >Selector No. | Function | Setting and Specifications | |
|
|
| |
| USB serial number (SN) | 0: USB serial number transmitted/ USB | |
1 | serial number not transmitted | ||
transmission enabled/disabled | |||
| 1: Frame length selection | ||
|
| ||
|
|
| |
2 |
|
| |
Not used. |
| ||
8 |
|
| |
|
|
|
- Selector 1: Frame length selection
This is intended to prevent the problem of a continued increase in USB ports when serial numbers are transmitted from the MFC to a Windows
It is intended only to prevent a problem specific to Windows Vista; its default setting is “0: USB SN enabled.”
App. | Confidential |