(1)Remove the cup S M3x8 Taptite screw and three cup B M4x12 Taptite screws.
(2)Release the three Hooks on the bottom and the two hooks on the back side, and then remove the Side cover L ASSY.
Note:
When removing the Side cover L ASSY, pay attention to the Wire support rope.
Hook
Taptite, cup B M4x12 (Tightening torque: 1.20 ±0.1 N m) *1
Hooks
Side cover L ASSY
Taptite, cup S M3x8
Hooks
Wire support rope
<Left side>
Taptite, cup B M4x12
(Tightening torque: 1.20 ±0.1 N m) *1
Fig.
*1 Tightening Note:
When tightening the screw, slowly turn it counterclockwise (in the direction to loosen the screw) with your hand until you feel that the screw is a little dropped in the hole. Then, slightly turn it clockwise (in the direction to tighten the screw) with your hand and tighten it according to the specified torque with a screwdriver.
(3) Remove the Access cover from the Side cover L ASSY.
Side cover L ASSY
3a
3b
<Left side>
Access cover
Fig.
Confidential |