8.48Toner Sensor PCB ASSY K, Y, M, C (TE/NEW)
(1)Remove the three cup B M3x10 Taptite screws, and then remove the Release drive holder from the Frame unit.
Release drive holder
Frame unit
Taptite, cup B M3x10 (Tightening torque: 0.70 ±0.1 N m) *1
<Left side >
Taptite, cup B M3x10
(Tightening torque: 0.70 ±0.1 N m) *1
Fig.
*1 Tightening Note:
When tightening the screw, slowly turn it counterclockwise (in the direction to loosen the screw) with your hand until you feel that the screw is a little dropped in the hole. Then, slightly turn it clockwise (in the direction to tighten the screw) with your hand and tighten it according to the specified torque with a screwdriver.
Confidential |