(3)Disconnect the two flat cables (CN1, CN4) and connector (CN8) from the Laser unit.
Note:
-After disconnecting the flat cable(s), check that each cable is not damaged at its end or
-When connecting the flat cable(s), do not insert it at an angle. After insertion, check that the cable is not at an angle.
Laser unit
<Front>
Fig.
(4)Remove the seven cup S M3x6 SR Taptite screws, and then remove the four Scanner holders and Laser unit.
Taptite, cup S M3x6 SR
Taptite, cup S M3x6 SR
Taptite, cup S M3x6 SR
Scanner holder Positioning boss
Scanner holder
Scanner holder
Laser unit
Positioning boss
Taptite, cup S M3x6 SR
Scanner holder
Frame unit
Positioning hole
Positioning hole | <Front> |
Fig.
Assembling Note:
When assembling the Laser unit with the Scanner holders, ensure to put the positioning boss of the Laser unit into the positioning hole referring to the figure above.
Confidential |