(3)Remove the two pan (washer) B M4x14 Taptite screws, and then pull out the Fuser unit to the back of the machine.

<Back side>

Taptite, pan (washer) B M4x14 (Tightening torque: 1.20 ±0.1 N m) *1

Fuser unit

Taptite, pan (washer) B M4x14 (Tightening torque: 1.20 ±0.1 N m) *1

Fig. 3-17

*1 Tightening Note:

When tightening the screw, slowly turn it counterclockwise (in the direction to loosen the screw) with your hand until you feel that the screw is a little dropped in the hole. Then, slightly turn it clockwise (in the direction to tighten the screw) with your hand and tighten it according to the specified torque with a screwdriver.

Assembling Note:

When assembling the fuser unit, make sure that the two Harnesses are placed in the groove and under the rib of the Plastic frame. If they are not, then correct them as shown

in the figure below.

Harness

 

Harness

Plastic frame

Fig. 3-18

3-41

Confidential