Overview
Configuration C
Figure 1-4 illustrates a server that is plugged into a load segment of a UPS. Both the UPS and the server are directly connected to the network. The UPS is monitored by a Management Server that is located elsewhere on the network. The server has an installed System Agent that receives commands, such as displaying a pop-up message or shutting down the operating system, from the Management Server.
NOTE: Installed agents must be associated with the correct server or UPS load segment in HP Rack and Power Manager. For information on associating agents, refer to “Attached Agents Screen” in Chapter 5.
Figure 1-4: Configuration C
Item Description
1HP Rack and Power Management Server*
2Additional servers power protected by a single UPS (each server requires installation of the System Agent)
3Power protected server (requires installation of the System Agent)
4UPS with an HP SNMP Adapter Card installed
5Utility power feed
*A dedicated Management Server is not required.
HP Rack and Power Manager User Guide |
