Installation

Example 2-4: Silent System Agent and Serial Relay Agent Installation

INSTALLER_UI = silent

CHOSEN_INSTALL_SET = agentSRA

USER_INSTALL_DIR = $/$opt$/$HP$/$RPM

USER_INPUT_CERT_PW_1 = Admin

USER_INPUT_SRA_COM = 2

USER_INPUT_RESULTS_START_1 = Start CRPM Services?

After saving the text file, run the installer by entering <path to install executable> -f <path to properties file> at the command prompt. For example, if the install executable (SETUP.EXE) is in the directory c:/hprpm and the properties file (INSTALL.PROP) is in the directory c:/docs, from a command prompt at c:/hprpm, enter:

SETUP.EXE –f C:/DOCS/INSTALL.PROP

Installing Components on NetWare Operating Systems

The System Agent and Serial Relay Agent can be installed using the GUI installation option or Silent installation option on any supported NetWare operating system.

Installing the Components Using the GUI Installation Method

Installing HP Rack and Power Manager Agents on NetWare requires two steps. Step one installs files to the NetWare server from a Windows workstation. Step two configures and loads the software on the NetWare server.

Requirements for installation:

•A Novell Client must be installed and configured on a Windows workstation.

NOTE: The account used to log into the NetWare server using the Novell Client should have appropriate file system rights to install HP Rack and Power Manager Agents.

•A drive must be mapped from the Windows workstation running the Novell Client to the root of the SYS: volume on the target NetWare server.

To install the components on a NetWare system using the GUI installation method:

1.Insert the Rack and Power Management CD into the Windows workstation running the Novell Client. Locate and run the NetWare Agent executable located in the HPRPM/NetWare folder (INSTALL.EXE).

The Introduction screen appears.

2-34

HP Rack and Power Manager User Guide