MERLIN LEGEND Communications System Release 6.0
System Programming
555-660-111 Issue 1
February 1998
Programming with SPM
Page2-5Installing the SPM Software
2
■Creates the following directories if they do not already exist:
— c:\spm\backup
— c:\spm\reports
—c:\spm\tmp
■Does one of the following:
— Creates the SPM configuration file c:\spm\ams.cfg, if it does not
already exist. In this case, the ams.cfg file consists of only one line,
in which the language attribute is specified: if you specified
English or did not specify a language with the command;
— Modifies the ams.cfg file, if it already exists, by adding or changing
the LANG value.
Follow the steps below to install SPM on the PC’s hard disk.
Switch to Drive A, if it is not already the current drive.
appears on the screen.
Insert the backup copy of the SPM diskette into Drive A.
Type one of the commands shown below and press .
■install
■install french
■install spanish
Because English is the default language, and have the
same result. If you do use the language argument ( , , or ), you
must type it in lowercase lett ers as shown. The command may be uppercase
or lowercase.
Wait for the message shown below to appear.
Press any key to begin the installation.
When the installation is finished, the following message appears:
Remove the SPM diskette from Drive A and reboot your system.
The installation procedure is complete.
Go to “Initializing the SPM Software” on page 2–9.