MERLIN LEGEND Communications System Release 6.0
System Programming
555-660-111 Issue 1
February 1998
Programming Procedures
Page4-6Basic System Operating Conditions
4
Factory Setting English
Valid Entries English, French, Spanish
Inspect No
Copy Option No
Console Procedure More→ → → →
Select a language→
PC Procedure →→→→Select a language→
Board Renumbering 4
!CAUTION:
!CAUTION:

This procedure is to be performed by qualified support personnel only.

Use this procedure to renumber boards that have already been i nstalled. This
procedure restarts the system (system programming is not lost). Note that this is
not the same procedure used with the Boards option, which is available to
qualified service personnel with SPM only.
Board Renumber is a system programming procedure that is required only w hen
an existing module is replaced by a different type of module. When a Board
Renumber is performed, the system reassigns the logical ID numbers to the
extension and line ports sequentially from left to right in the control unit and from
bottom to top of each module.
Summary: Board Renumbering 4
Programmable by Qualified support personnel only
Mode All
Idle Condition System idle
Planning Form Not applicable
Factory Setting None
Valid Entries Not applicab le
Inspect Not applicable
Copy Option Not applicable
Console Procedure → →
PC Procedure → →