MERLIN LEGEND Communications System Release 6.0
System Programming
555-660-111 Issue 1
February 1998
Common Administrative Procedures
Page4-405UDP (Uniform Dial Plan) Routing
4
Console/Display Instructions Additional Information PC
Save your entry.
Select .
Return to the System Programming menu.
Select four times.
UDP Facility Restriction Level 4
Use this procedure to assign a Facilit y Restriction Level (FRL) to each UDP route.
The FRL ranges from 0 (least restrictive) to 6 (most restrictive) and prevents users
from accessing the route. The FRL assigned to extensions and remote access
users is the opposite of the FRL assigned to routes, where 0 is the most restrictive
and 6 is the least restrictive. A call will succeed if the extension’s FRL i s greater
than or equal to the facility’s FRL.
FRLs assigned to extensions apply not only to ARS calls but also to calls for non-
local dial plan extensions connected by private trunks to your local system. For
this reason, use care in assigning FRLs both to extensions an d to UDP routes.
For example, if a user must be restricted from toll calls on your local system, you
may need to plan UDP routes’ FRLs to be unrestricted, so that the user can reach
necessary non-local dial plan extensions. For information about assigning FRLs to
extensions, see “ARS Restriction Level For Extensions” on page 3–108.
NOTES:
1. UDP pool routes must be programmed before you assign Facility
Restriction Levels to those routes.
2. Extension outward and toll calling restrictions are removed when a user
dials a non-local dial plan extension. However, FRL extension
restrictions remain in effect.
Summary: UDP Route Faci lity Restriction Level 4
Programmable by System Manager
Mode Hybrid/PBX
Idle Condition Not required
Planning Form Non-Local Dial Plan Administration Form in the Installation
Specification
Factory Setting 3
Valid Entries 0 to 6