MERLIN LEGEND Communications System Release 6.0
System Programming
555-660-111 Issue 1
February 1998
Common Administrative Procedures
Page4-363Automatic Route Selection
4
Automatic Route Selectio n 4
This section contains programming procedures for the following Automatic Route
Selection (ARS) features:
■1 + 7-Digit Dialing Requirements
■ARS Tables
■Start and Stop Times for Subpatterns
■Pool Routing
■Facility Restriction Level (FRL)
■Digit Absorption
■Other Digits
■N11 Special Numbers Tables
■Dial 0 Tab le
■Voice and/or Data Routing
NOTE:NOTE:NOTE:
ARS applies to Hybrid/PBX mode only.

ARS over Networked Tandem PRI

and TieTrunks 4

In Release 6.0 and later systems, Hybrid/PBX mode only, callers on one system
can use lines on another system speedily and transparently when optimal cost
efficiency dictates the need for lines connected to a different switch in the
organization’s private network (in prior systems, it is necessary to make an explicit
remote-access call, enter a barrier code, and finally use ARS). To permit this
operation, both the local and remote systems must be programmed using ARS
and remote access options.

Remote Users Calling out on Local

Networked Lines 4

To implement this operation on a local system where remote callers will use the
networked lines connected to your system, use the procedures outlined in the
section “Remote Access Features” on page –337.