Lucent Technologies 6.0 Select backup file

MERLIN LEGEND Communications System Release 6.0
System Programming
555-660-111 Issue 1 February 1998
Common Administrative Procedures
Page3-283Memory Card
3
NOTE:NOTE:NOTE:
If the system performs a System Erase (frigid start), all programming is set
to the default values. If a previous backup file is available, perform a
restore. If not, the system must be reprogrammed. See “Restore” on page
–447 for information about the system restore procedure. Also see “Backup
Messages” on page –290 for information about errors that may occur during
the backup procedure.
Summary: Backup 3
Programmable by System Manager
Mode All
Idle Condition Not required (No extensions are allowed to be in
programming mode except system programming console)
Planning Form Form 1, System Planning
Factory Setting Not applicable
Valid Entries 1- to 11-character filename
Inspect Yes
Copy Option No
Console Procedure Insert memory card→ → →
→Select backup file→Dial the new backup
filename→ → → → →
PC Procedure Insert memory card→→→→Select backup
file→Type the new backup filename→→→
→ →
Procedure: Backup 3
Console Display/Instructions Additional Information PC
Insert the memory card into the PCMCIA interface slot on the
processor module.
See Figure 3–5, “Inserting the Memory Card.”