Buhler 2290, 2335, 2425, 2375, 2360 manual Key to the Engine Start Position Engine Cranking

SECTION 2 - OPERATION

Key to the “ENGINE START” Position - Engine Cranking

When the key turns to the “ENGINE START” position, the engine starts to crank and the four lights illuminated with the switch in the “RUN” position remain on.

Key in the “RUN” Position - Engine Running

Once the engine is running, the Engine Oil Pressure and Transmission Lube Pressure lamps will go out as soon as sufficient pressure builds up to cancel the warnings. The alternator output lamp will also go out when the alternator begins to charge. The park brake goes out when the park brake is released. Any other illuminated light indicates a problem.

NOTE: In low, ambient temperatures the transmission lube filter and the hydraulic filter by-pass light may stay on until the oil reaches operating temperature.

At first key “ON” the following warning lamps will illuminate

After a few seconds only the following warning lamps should remain on

PARK BRAKE MUST BE ENGAGED FOR THIS LAMP TO BE ON.

ALTERNATOR NOT CHARGING LAMP WILL REMAIN ON UNTIL ENGINE IS RUNNING

ENGINE COOLANT LEVEL LAMP

WILL ONLY REMAIN ILLUMINATED

IF THE ENGINE COOLANT LEVEL IS LOW.

ENGINE OIL PRESSURE LAMP

WILL REMAIN ON UNTIL ENGINE IS RUNNING

	RED ENGINE WARNING LAMP WILL REMAIN
	ILLUMINATED ONLY IF AN ENGINE FAULT
	CODE IS ACTIVE. REFER TO ENGINE
	DIAGNOSTIC SECTION IF THIS LAMP
	REMAINS ON.
TRANSMISSION LUBE PRESSURE	YELLOW ENGINE WARNING LAMP WILL
MUST REMAIN ILLUMINATED. IF	REMAIN ILLUMINATED ONLY IF AN ENGINE
LAMP DOES NOT TURN ON CHECK	FAULT CODE IS ACTIVE. REFER TO ENGINE
TRANSMISSION LUBE PRESSURE	DIAGNOSTICS SECTION IF THIS LAMP
SWITCH ON TRANSMISSION.	REMAINS ON.

2-54