Buhler 2360, 2335, 2425, 2290, 2375 manual Engine, QSM11

SECTION 2 - OPERATION

9. Setting the Engine Flywheel Ring Gear Profile

NOTE: This value is set when the machine is built. It does not require operator setup, and should never be changed. Instructions are provided here only in the event the value was inadvertently changed.

A. The upper portion of the monitor will flash “ENG” and “SET” with “SETUP” displayed. The lower portion of the display will show 103 or 12, depending on current programmed selection.

B. Use the following chart to determine

which “ENG”	number	should be
programmed into the EIC:
Model	Engine	“ENG”
Number		Number
2290, 2335,	QSM11	12
2375
2360, 2425	N14	103

C. To place the correct value into the monitor, use the digit select switch. Move the switch up for 103, or down for 12.

D. Press the Acknowledge/Reset button to enter the value into the monitor’s memory. The display will now return to “Setting the Final Drive Ratio.”

All possible programming for the hours position is now complete. If no further calibration is needed, turn the ignition to the “OFF” position.

Figure 2-103

12

Figure 2-104

2-71