Buhler 2375, 2335, 2425, 2290, 2360 manual Implement Status Switch, 110

SECTION 2 - OPERATION

IMPLEMENT STATUS SWITCH

The implement status switch is to be mounted to the tractor for 3-point hitch applications, or to the implement for drawbar applications, to provide an “on/off” signal to the Tractor Performance Monitor (TPM) to start and stop the calculation of the area covered.

Examples of various mounting arrangements are shown:

A. Tractor Equipped with 3-Point Hitch - The implement status switch is attached to the fender and connected to the lift arm.

B. Remote Mount to an Implement - The implement status switch is attached to the linkage that lifts the implement.

Instructions for mounting the switch are provided with the kit. Tractors with a factory- installed TPM will have the switch shipped with it.

Figure 2-140

Figure 2-141

Figure 2-142

2-110