Buhler 2360, 2335, 2425, 2290, 2375 manual Float Mechanical, Sway Blocks, 141

SECTION 2 - OPERATION

Float (Mechanical)

To put the lift links into mechanical float position, remove the pin, 1, securing the lower link to the hole on the lift link. Reconnect the lower link to the lift link using the slot on the lift link. Reverse this procedure to convert to non-float position.

When in this position, the hitch will float approximately 76mm (3″) when fully lowered.

NOTE: Full float position is achieved by adjusting the hitch position knob on the side console to its float detent position when in the automatic mode.

Sway Blocks

Sway blocks, 1, have two positions for use with the 3-point hitch. When the blocks are in the sway position, the lower links can move side to side approximately 51mm (2″). When in the non-sway position, the lift arms will be limited in their side-to-side movement when hooked to an implement.

When the sway blocks, 1, are in the sway position, the block is rotated so that the narrow end of the block is downward.

1

Figure 2-196

1

Figure 2-197

1

Figure 2-198

2-141