Buhler 2360, 2335, 2425, 2290, 2375 manual Check the Throttle Settings

SECTION 3 - LUBRICATION AND MAINTENANCE

AS REQUIRED

The fuse and relay panel is clearly marked for all electrical functions. There are no circuit breakers on Buhler Versatile 4WD tractors. Not all relays that are used in the electrical system are housed in the fuse and relay panel area. If equipped with a powershift transmission, the neutral relay is located near the powershift control under the RH console. The brake/tail light relays (2 used) are located near the lower RH rear corner of the CAB, below the fuse/relay panel. In-line fuses for the optional ‘Back--up Alarm’, ‘Beacon Light’, ‘Motorized Flow Control’ are located beside the fuse/relay panel.

There are extra fuses, 1, located at the front of the fuse panel and a fuse removing tool, 2, is located in the right front corner of the panel. The fuses are clearly marked for amperage rating.

2 1

Figure 3-114

OPERATION 66

Check the Throttle Settings

DANGER: ANY THROTTLE ADJUSTMENT MUST BE MADE WITH THE ENGINE OFF AND THE PARK BRAKE APPLIED.

The throttle settings for the engine are controlled by the electronic module, 1, on the engine. The low idle speed is 850 -- 900 RPM. High idle speed is 2225 ± 50 RPM. All settings are adjustable only by an authorized Buhler Versatile dealer or Cummins dealer/distributor.

(2360 and 2425 models illustrated)

1

Figure 3-115

3-70