Buhler 2290, 2335, 2425, 2375, 2360 manual Hitch Adjustments, Lower Links, Lift Links, Upper Link, 139

SECTION 2 - OPERATION

HITCH ADJUSTMENTS

Lower Links

When the lift links are adjusted halfway, the lower link hitch point, 1, should be 200 mm - 250 mm (8″ - 10″) from the ground when the lift cylinders are fully retracted. Be sure that the implement is level on the right and left sides of the hitch by adjusting the lift link length.

1

Lift Links

The lift links, 1, on the 3-point hitch may be adjusted to level the hitch or an implement from side to side by turning the latch handle, 2, on the link to raise or lower that side of the hitch. Fold the handle out and turn it until the lift link is adjusted. Return the handle to the storage position by lining up the square sides of the threaded lift link rod with the handle and snapping it down onto the lift link.

NOTE: Only level the implement side to side when it is in the full down position and the weight is off the hitch.

Upper Link

1

Figure 2-190

2

Figure 2-191

The upper link, 1, is used to level the implement from front to rear. Loosen the locking plates, 2, on the upper link. Turn the center collar to shorten or lengthen the upper link to level the implement. Tighten the locking plates.

1

2

Figure 2-192

2-139